Huffy m0381 Manual Del Propietário página 5

Scooter Assembly - continued
REAR AXLE / WHEEL ASSEMBLY:
1. Install Rear Frame Caps
2. Place one Wheel
• NOTE: Ensure Axle Spacer side of Wheel
3. Slide the Axle Bolt and Wheel through the rear of the Frame and Frame Caps as shown.
4. Ensure Axle Spacer side of Wheel
Bolt.
5. Place a Washer
6. Tighten Nut securely.
WARNING: The nylon Locking Nuts
ensure wheels do not come loose from the axle.
FRONT HANDLEBAR / FORK ASSEMBLY:
Two Piece Handlebar Assembly:
1. Place the Handlebar
2. Insert two Screws
Stem Tube mount.
3. Place a Washer
4. Tighten the Nuts securely.
ATTACHING HANDLEBAR ASSEMBLY TO FORK TUBE:
1. Insert Fork Assembly
Neck Bushings
2. Place large Washer
3. Slide Clamp Cover
4. Ensure handlebar assembly is facing forward and insert into Fork Tube:
WARNING: Ensure that the Minimum Insertion Mark
ible - below the top of the Steerer Tube.
5. Align Handlebar with Fork assembly and tighten Clamp
6. Place Clamp Cover
7. Install Handlebar Pad/Bag
NOTE: Handlebar Bag weight limit 5 lbs (2.3 kgs).
onto rear Frame
q
onto Axle Bolt
e
X
and Nut onto the Axle Bolt.
y u
onto the Steering Tube
i
through the holes in the Handlebar and the mating holes in the
a
and Nut onto each screw.
s d
info Frame Tube
g
C do not come lose.
onto Fork Tube
h
and Clamp
j k
over Clamp.
j
(if equipped) by securing with Velcro or straps.
2)
as shown (may be pre-installed).
w
.
t
is facing IN.
X
is facing IN and place other Wheel
must be fully engaged on the thread to
u
.
o
A with Slot B
.
g
up on Steering Tube
e
facing to the rear. Make sure
.
o
D on the stem tube is not vis-
Bolt securely.
k
onto Axle
5