Amann Girrbach Hand Scanner & IntelliCode Instrucciones De Uso página 16

O P E R AT I N G I N S T R U C T I O N S
3.3 Creating new blanks in the CAM software
EN
Fig. 10
Fig. 11
Fig. 12
16
1) Creating a round or horseshoe-shaped
blank in the CAM software
Open the CAM software and click in the
field with the cursor
#
Scanning the IntelliCode on the blank
packaging:
_ Scan the IntelliCode using the
hand scanner
_ Click on "Generate" and "Use
immediately" (Fig. 11)
(2) Creating a block (e.g. VITABLOCS Mark
II) in the CAM software:
_ Select the required material in the
database (Fig. 12)
#
_ Click in the field with the cursor in
_ Scan the IntelliCode on the packaging
# (Fig. 10)
#