Electrical Safety; Preparing For Commissioning - Toolland VL6000 Manual Del Usuario

Unless otherwise indicated in the operating instructions, damaged safety devices and parts must be
o
properly repaired or replaced by an unauthorised workshop (or by the manufacturer).
Damaged or illegible safety warning labels should be replaced immediately.
o
 Do not allow any tool key be plugged in. before switching on, always check that wrenches and adjusting
tools are removed.
 Store unused equipment in a dry, locked place out of the reach of children.
5.

Electrical Safety

 Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core-profile section of at least
1.5 mm³ for cable lengths up to 25 m.
 Long and thin connection lines result in a potential drop. The motor does not reach any longer its maximal
power; the function of the devices is reduced.
 Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other
thermoplastic material of the same mechanical stability or to be covered with this material.
 The connector of the connection cable must be splash-proof.
 When running the connection line observe that it does not interfere, is not squeezed, bended and the plug
connection does not get wet.
 Wind off the cable completely when using a cable drum.
 Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp
edges. Do not use the cable to pull the plug from the socket.
 Protect yourself against electric shocks. Avoid touching earthed parts with your body (e.g. pipes, heating
apparatus, cookers, fridges, etc.).
 Regularly check the extension cables and replace them if they are damaged.
 Do not use any defective connection cables.
 Do not set up any provisional electrical connections.
 Never bypass protective devices or deactivate them.
The electrical connection or repairs to electrical parts of the machine must be carried out by a
certified electrician. Local regulations – especially regarding protective measures – must be
observed.
Repairs to other .parts of the machine must be carried out by the manufacturer.
Only use original spare parts, accessories and special accessory parts. Accidents can arise for the
user through the use of other spare parts. Velleman nv is not liable for damage or injury resulting
from such action.
6.

Preparing for Commissioning

To achieve perfect function of the machine, follow the notes given in these instructions.
You must still do the following:
 Mount the rotary table.
 Set up the device securely.
6.1 Assembling the Rotary Table
1. Place the rotary table (1) onto the supporting table (2).
2. Thread the mounting nut (7) on the locking screw.
6.2 Mounting the Chain Sharpener on a Workbench
For secure handling, the device must be mounted along the edge of a workbench or table (a). Use all three
fixing points if possible. But make sure that the recess for the saw chain remains free and the locking nut
remains accessible.
Hint: We recommend the additional placement of a rubber pad (b) to reduce noise and vibration (not included).
V. 01 – 05/06/2015
VL6000
6 ©Velleman nv