Tabla de contenido
Publicidad
en
Installation
Please detach the illustrated centre pages
before reading the installation instructions.
You can now read the text in conjunction
with the illustrations.
Installation location
A dry, well ventilated room is suitable as
an installation location. The appliance
should not be installed in direct sunlight or
near a heat source (e.g. radiator, cooker).
If required, use an insulating plate or
observe the following minimum distances
from the heat source.
3 cm to an electric cooker.
30 cm to an oil or solid fuel cooker.
6
Installing the appliance
A Torx T 20 screwdriver is required for
installation.
The required fixtures are enclosed with
the appliance.
Important!
To protect the glass door, do not remove
the transportation protection devices until
the appliance has been placed in the
cavity. Fig. 5
If installing the appliance in a room divider,
line the rear of the installation cavity in the
area of the appliance.
1. Carefully align the high sided unit with
a spirit level. Fig. 1/1
The high sided unit must be screwed
securely to the adjacent units,
Fig. 1/2, or to the wall. Fig. 1/3
2. The appliance must be ventilated by
an opening in the base and a duct at
the rear of the high sided unit. Fig. 2
Minimum cross section of the
ventilation openings in the base and
duct: 200 cm
3. Install the power cord and pull into
the required position with a piece
of string, ensuring that the socket
is accessible after the appliance has
been installed. Slide appliance into
the high sided unit. Do not trap the
power cord. Fig. 3
4. When the door is open, insert the
cover strip into the sheet metal
brackets on the housing. Fig. 4/1
Screw on the cover strip with the
enclosed screws. Fig. 4/2
2
.
Publicidad
Tabla de contenido
