Tabla de contenido
Publicidad
5. Removing the transportation
protection devices:
Unscrew the screwed on parts.
Fig. 5/1
Remove the glued on transportation
protection devices. Fig. 5/2
Hold the plastic part, do not press on
it. Take hold of the tab and slowly pull
out the strip straight and parallel to the
base.
Fit enclosed cover to the housing.
Fig. 5/3
Attach magnet. Fig. 5/4
Insert the caps. Fig. 5/5
6. Insert the enclosed cavity fixture,
Fig. 6/1, into the housing.
Adjust the profiled strip, Fig. 6/2,
to the inside height of the high sided
unit and glue to the housing on the
door opening side.
If the side panels of the high sided
unit are 16 mm (or thinner), separate
the enclosed spacers, Fig. 6/3,
and insert into the hinge arms.
7. Push the appliance into the
high sided unit until the stop bar
at the top, Fig. 7/1, and the stops
on the door hinges, Fig. 7/2, are
situated on the front edge of the
high sided unit. Move the hinge side
of the appliance right up to the side
panel of the high sided unit.
8. Screw the appliance to the high sided
unit at the side, Fig. 8/1, at the top,
Fig. 8/2, and at the bottom. Fig. 8/3
Insert the caps. Fig. 8/4
9. Loosen the screws, Fig. 9/1, and
align the door. Retighten the screws.
Push the caps, Fig. 9/2, onto the
hinges.
Attach the door handle. Fig. 9/3
To prevent damage, the door handle
is enclosed loosely with the appliance.
Electrical connection
The socket should be freely accessible,
preferably above the high sided unit.
Do not operate the appliance until it has
been installed.
When sliding the appliance into the
high sided unit, do not pinch the power
cord.
Connect the appliance to 220 240 V/
50 Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10 A
fuse or higher. If the appliance is to be
operated in a non European country,
check on the rating plate whether the
indicated supply voltage, current type and
frequency of the appliance correspond
with the specifications of your power
supply. The rating plate is situated in the
bottom left hand side of the appliance.
The power cord may be replaced by
a technician only.
Installation dimensions
Fig. 0
en
7
Publicidad
Tabla de contenido
