Tripp-Lite AVRX550U Manual Del Propietário página 4

Features
continued
F SURGE AND NOISE PROTECTED OUTLETS
Provide surge protection only. Plug non- or less-critcal equipment not requiring battery backup into these outlets.
G
AC INLET (C14)
Accepts a user-supplied power cord with a country-specific plug.
H USB COMMUNICATION PORT (HID Compliant)
This port can connect your UPS to any computer for automatic file saves and unattended shutdown in the event of a power failure. Use with
Tripp Lite's PowerAlert software and appropriate USB cable. A PowerAlert CD and USB cable may be included with your UPS; if so, insert
the CD into the CD tray of your computer and follow the installation instructions. If PowerAlert software and the appropriate cable did not
come with your UPS, you can obtain the software FREE via the Web at www.tripplite.com. This port can also be used with the built-in power
management utilities of Mac OS
used to connect your UPS to your computer. NOTE: This connection is optional. The UPS will work properly without this connection.
CAUTION: Users must take proper care to minimize electrostatic events. In the event of a severe electrostatic discharge on or near the
USB port, this UPS may shut down automatically. In the case of a shut down, the UPS will need to be turned back on.
I TEL/DSL PROTECTION JACKS
Stop surges on the phone or fax line. Connecting your equipment to these jacks is optional. Your UPS will work properly without this
connection.
J GROUND CONNECTION
Use this to connect any equipment that requires a chassis ground.
K
BATTERY REPLACEMENT DOOR (bottom panel, not shown)
Under normal conditions, the original battery in your UPS will last several years. Battery replacement should be performed only by qualified
service personnel. Refer to "Battery Warnings" in the Safety section. Should your UPS require battery replacement, visit Tripp Lite on the Web
at www.tripplite.com/support/battery/index.cfm to locate the specific replacement battery for your UPS.
Installation
1
STEP 1: Unplug the computer's power cord
from both your AC outlet and the computer's
AC input. Insert the female end (C13) of the
computer's cord into your UPS's AC inlet
A
(C14). Insert the male plug of your computer's
cord into your AC outlet. Insert the female end
(C13) of the power cord that came with your
UPS into the computer's AC input. Insert the
B
power cord's male end (C14) into any of your
UPS's battery backup outlets.
® , Linux ® and Windows ® for basic system shutdown and monitoring functions. Any USB cable may then be
2
STEP 2: Plug remaining equipment into the
UPS.
3
STEP 3: Push the ON/OFF/TEST button for
one second to turn the UPS on (see Features
Section). Please Note! The UPS will not turn
on automatically in the presence of live utility
power.
Note: UPS system will function properly upon initial
startup; however, maximum runtime for the unit's
battery will only be accessible after it has been
charged for 24 hours.
4