Getting Started; Cancel The Demonstration; Set The Clock; Set The Basic Settings - JVCKENWOOD KD-R775S Manual De Instrucciones

GETTING STARTED

KD-R370
1

Cancel the demonstration

When you turn on the power (or after you reset the unit), the display
shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock

1
Press and hold .
2
Turn the volume knob to select [CLOCK], then press the knob.
3
Turn the volume knob to select [CLOCK SET], then press the knob.
4
Turn the volume knob to make the settings, then press the knob.
Day Hour Minute
5
Turn the volume knob to select [24H/ 12H], then press the knob.
6
Turn the volume knob to select [12 HOUR] or [24 HOUR], then press the
knob.
7
Press to exit.
To return to the previous setting item, press
4
3
1
Press and hold
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3
Repeat step
4
Press
To return to the previous setting item, press
SETTINGS
BEEP
SRC SELECT
AM *
PANDORA *
IHEART *
AUX *
FUNCTION
.
* 1
Not displayed when the corresponding source is selected.
* 2
Applicable only if [AUX] is set to [ON].

Set the basic settings

.
2
until the desired item is selected or activated.
to exit.
ON: Activates the keypress tone. ; OFF: Deactivates.
1
ON: Enables AM in source selection. ; OFF: Disables.
1 (For KD-R775S / KD-R670)
ON: Enables PANDORA in source selection. ; OFF: Disables.
1
(For KD-R775S / KD-R670)
ON: Enables IHEARTRADIO in source selection. ; OFF: Disables.
1
BT ADAPTER: Selects when the KS-BTA100 Bluetooth adapter is connected
to the AUX jack. ( 14) ; ON: Enables AUX in source selection. ; OFF: Disables.
(For KD-R370)
Select the feature for FUNCTION button.
DIMMER: Press FUNCTION to turn on or off the dimmer. This operation
overwrites the [DIMMER] settings in menu. ( 17)
BRIGHTNESS: Press FUNCTION to enter [BRIGHTNESS] menu directly.
( 17)
BASS BOOST: Press FUNCTION to enter [BASS BOOST] menu directly.
( 15)
AUX: Press FUNCTION to select AUX directly. *
.
Default: XX
2
( 14)