General Guidelines; User Manual - Velleman KSR2 Manual Del Usuario

Rana robot
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
The KSR2 is a robot frog that uses a microphone as a detector. The car changes directions when the sensor
detects noise or when the car hits an object.
The KSR2 requires one 9V DC battery (not included) for the electronic parts and 2x AA-batteries of 1.5V for the
mechanical parts (not included).
Apart from the batteries, you will also need a length of solder wire, a pair of long-nose pliers, a soldering iron, a
diagonal cutter, a screwdriver and a soldering iron stand with sponge.
2.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
3.
Electronic Parts List
1.
resistor: 2 x 100 (brown/black/brown/gold)
2 x 4.7K (yellow/violet/red/gold)
1 x 10K (brown/black/orange/gold)
1 x 22K (red/red/orange/gold)
5 x 33K (orange/orange/orange/gold)
2 x 2.7M (red/violet/green/gold)
2.
battery snap with wires 15cm (1 x)
3.
battery holder with wires 8cm (1 x)
4.
transistor: 2 x type 1815 (or C945) and 2 x
type 8050
5.
IC: 1 x type 4017 and 1 x type 406P
6.
ceramic capacitor 47P (1 x)
7.
electrolytic capacitor 1uf (2 x)
8.
diode IN 4148 (6 x)
9.
mylar capacitor 103 (1 x)
10.
microphone Ø10mm (1 x)
11.
variable resistor 200K (1 x)
12.
slide switch (1 x)
13.
Ø1.3mm pin (8 x)
14.
connector with wire 15cm: 1 x yellow, 1 x
blue, 1 x orange, 1 x green
15.
PCB (1 x)
V. 02 – 31/01/2018
KSR2

USER MANUAL

2
Fig. 1
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido