Starrett S8010 Manual De Instruccion página 126

4. KEEP the speed and pressure so that it is possible to cut without
overheating the drill bit. APPLYING too much pressure may cause:
- Machine to overheat;
- Bearing wear;
- Sprung or burnt drill bits;
- Irregular or decentralized holes.
SCREWDRIVER OPERATION:
FIG 13
The Drill/Driver S8010 has as accessory a Bit (fi gure 13) clamped by a Clip
(Bit Storage).
The Bit is used to tighten or loosen screw head as Phillips or Slotted.
The installation is similar of a drill and can be tightened by Keyless Chuck.
It is RECOMMENDED REMOVE and STORE on the Bit Storage whenever the
machine is off.
126 S8010
BIT STORAGE
(CLIP)
BIT
ENGLISH