Hama EWS-820 Instrucciones De Uso página 8

Display
Display flashing
Displayed continuously
Not displayed
• If the station still does not receive a signal, press and hold the + button (27) ) and the – button (28) for
approx. 3 seconds to start the manual search for the DCF signal. The wireless symbol (5) will start to flash.
Note – Time settings
• The search process takes about 7 minutes. If the search fails, it ends and is repeated at the next clock
hour. The wireless symbol (5) will go out.
• In the meantime you can, however, set the time and the date manually.
• The clock automatically continues to search for the DCF signal on a daily basis (between 1:00 a.m. and
3:00 a.m.). If the signal is received successfully, the manually-set time and date are overwritten.
Note – Summer time
• The clock automatically switches to summer time. S (19) appears on the display as long as summer time
is activated.
• Press and hold the + button (27) and the – button (28) again for approx. 3 seconds to stop the manual
search.
(Manual) settings
• Press and hold the + button (27) and the – button (28) for approx. 3 seconds to stop the search for the
DCF signal. The wireless symbol (5) goes out and you can set the time manually.
• Press and hold the MODE button (26) for approx. 3 seconds to make the following settings one after the
other:
• Year (4)
• Month (2)
• Day (1)
• Time zone (4)
• Weekday (3)
• 12/24 hour format (4)
• Hours (4)
• Minutes (4)
Searching for the DCF signal
Active
Successful – signal is being received
Deactivated
7