Hama EWS-380 Instrucciones De Uso página 7

TREND
6.5. Using and searching for moon phases
The weather station has a display for moon phases and a
corresponding search feature.
The following eight moon ph
Display
6.7. Comfort level – Display
The comfort level display is based on the following weather conditions:
Display
COM
(pleasant)
WET
(too moist)
DRY
(too dry)
No symbol
6.8. Changing the temperature warning settings
• Press the TEMP AL. button (12) to select the upper
limit value for the temperature warning.
• Then hold down the TEMP AL. button (12) for 2 seconds.
6
Decreasing
Meaning
ases are displayed:
New moon
Waxing crescent
First quarter
Waxing half moon
Full moon
Waning half moon
Temperature range
20° C to 25° C
(68° F to 77° F)
-5° C to +50° C
(23° F to 122° F)
-5° C to +50° C
(23° F to 122° F)
Below 20° C (68° F) or
above 25° C (77° F)
or lower
To display the moon phase on a specific day, proceed as follows:
• Press the button (19) or the
compartment to switch to moon phase search mode and select
your desired date.
Note
In this mode, the date is displayed day by day. You can go up to
39 days forward or back. The relevant moon phase is displayed
immediately.
• The unit returns to the previous display mode if you do not press
the button (19) or
to switch to moon phase search mode and select your desired
date.
6.6. Maximum and minimum temperature and humidity
values
The base station automatically stores the maximum and minimum
outdoor/indoor temperature values.
• Press the MEM button (21) to switch between the current
temperature, minimum temperature (MIN) and maximum
temperature (MAX).
• Press and hold the MEM button (21) for approx. 3 seconds to
reset the stored maximum and minimum values.
• If you press the MEM button (21) again, the minimum and
maximum values displayed remain unchanged until the next
update.
Humidity range
40% to 70% relative humidity
Above 70% relative humidity
Under 40% relative humidity
40% to 70% relative humidity
• Use the arrow buttons
value for the temperature warning.
• Press the TEMP AL. button (12) again to complete the process.
Last quarter
Waning crescent
button (20) in the battery
button (20) in the battery compartment
The corresponding weather
conditions
Optimum temperature and humidity
Excessively wet conditions
Excessively dry conditions
No weather information
(11) or (13) to set the selected limit