Mondolfo Ferro MT 3800 LASER Manual De Uso página 63

machine emits an acoustic confirmation signal
to indicate that the distance and diameter
values have been acquired.
- Return the end of the automatic measuring arm
in line with the plane selected for the applic-
ation of the outer weight (fig. 21), following
the same procedure previously indicated for
the inner side.
- Keep the arm in position and wait for the
acoustic confirmation signal.
- Return the measuring arm to the rest position.
- Perform a spin.
- At the end of the spin, if you want to change
the balancing programme set automatically
by the machine (FSP), select the balancing
programme icon
knob or the ENTER button
the required programme is displayed.
Balancing weight application
- Select the plane where the first balancing
weight is to be applied.
- Turn the wheel until the central element of
the corresponding position indicator lights up.
If the weight to be applied is of the traditional
clip type (inner side in Easy ALU 2), apply it to
the 12 o'clock position. If instead the weight
to apply is adhesive and the CLIP mode was
selected (see the " Selection of adhesive weight
application position"):
MT 3800 LASER - Operator's manual
21
and press the Kis
until
- Centre it inside the cavity of the weight-holder
terminal of the measuring arm (fig. 22 a,b),
with the backing paper of the adhesive strip
facing up. Remove the protection (fig. 22 c)
and turn the terminal so that the adhesive
faces the inner surface of the rim.
- Move the sensor until the two reference lines
(green in colour) coincide in the relevant
windows on the screen.
- Turn the end of the measuring arm until the
weight adhesive strip is in line with the rim
surface.
- Press the button (fig. 22 d) to eject the weight
and make it stick to the rim.
- Return the measuring arm to the rest position
(fig. 22 e).
a
b
d
- Repeat the operations to apply the second
balancing weight.
- Perform a test wheel spin to check the balan-
cing accuracy.
- If the weight to apply is adhesive and H12 mode
was selected, apply it on both the planes in
the position corresponding to 12 o'clock.
- If the weight to apply is adhesive and the
LASER mode was selected, apply the weight in
correspondence of the laser line in the position
in which the respective plane was acquired.
The rim surface must be perfectly clean to
make the weight stick efficiently to the rim.
If necessary, clean the surface using suitable
cleansing products.
NOTE: on the wheel balancers for the German
market, the weight must be applied as follows:
apply the weight manually by positioning it so
that its centre line is 15mm back from the con-
tact point of the measuring head with the rim.
c
e
22
UK
63