Velleman VTUSCT6 Manual Del Usuario página 6

6.
Solid green – the water temperature is at 0-30 % of the set temperature.
Solid orange – the water temperature is at 30-60 % of the set temperature.
Solid red – the water temperature is at 60-90 % of the set temperature.
Red flashing – the water temperature is close to the set temperature.
All solid – the water temperature is at the set temperature.
7. – set temperature
Indication of the selected temperature setting. See 16. Temp.
8. – solution remaining time
Counts down after the solution function is started.
9. – degas status indicator
Appears when the degassing function is selected, flashes when the degassing process is
engaged.
10. – normal cleaning status indicator
Appears when the normal cleaning function is selected.
11. – heater status indicator
Flashes when the heater is turned on, dims when heater is turned off.
12. – solution warning indicator
Appears when the solution cleaning function is selected, flashes when the solution needs to be
changed.
13. – temperature unit indicator
°C: set temperature in °C.
°F: set temperature in °F.
14. Solution
Press to add 20 minutes to the timer for the solution cleaning function.
8:88 indicates that the function is set to 1 hour and 20 minutes (max. 9 hours and 60 minutes).
15. Time
Press to increase the cleaning time by five minutes.
16. Temp
Press to select one of the five temperature settings.
17. – decrease button
Press to reduce the timer by one minute when the timer function is selected.
Press to select the previous temperature setting when the temperature function is selected.
Press to reduce the timer by 20 minutes when the solution cleaning function is selected.
Note on the Degas Function
A heavily soiled or greasy object, silver, copper or brass needs to be cleaned with added chemical solutions.
These solutions may form small droplets and take a long time to dissolve in the water. Filling the tank or adding
water may cause air bubbles to form onto the tank walls. These bubbles will reduce the cleaning effect. The
degas function will dissipate droplets and air bubbles, and improve the cleaning efficiency.
Included Accessories
1 plastic basket
2 cleaning tank
3 power cord
6. Operation
General Operation
Refer to the illustrations on pages 2 and 3 of this manual.
1. Remove the lid and place it on the lid holders. Put the object(s) into the basket and place the basket inside
the tank. Fill the tank with regular tap water to a level between the MIN and MAX markings, and so that the
object(s) is (are) completely immerged.
Never operate the ultrasonic cleaner without water in the tank to avoid damage to the cleaner!
V. 001 – 19/06/2014
– multistage temperature indicator
VTUSCT6
4 suspension strip x 2
5 drainage tube
6 ©Velleman nv