General Safety Instructions; General Safety Regulations - Astralpool FIJI Serie Manual De Instalación Y Mantenimiento

IMPORTANT
This manual contains basic information on the safety measures to be adopted during installation and start-up. The fitter
and the user must therefore read the instructions before installation and start-up.

1. GENERAL SAFETY INSTRUCTIONS

These symbols (
DANGER. Risk of electrocution.
Failure to abide by these instructions may lead to the risk of electrocution.
DANGER.
Failure to abide by these instructions may lead to the risk of injury or damage.
WARNING.
Failure to abide by these instructions may lead to the risk of damage to the pump or the installation.

2. GENERAL SAFETY REGULATIONS

GENERAL
- The machines indicated in this Manual are especially designed for the pre-filtering and recirculation of water in
swimming pools.
- They are designed to work with clean water at temperatures not exceeding 35ºC.
- Install them in line with the specific instructions for each installation.
- Respect current regulations regarding accident prevention.
- All modifications to the pump require prior authorisation from the manufacturer. Original spare parts and
accessories authorised by the manufacturer ensure greater safety. The pump manufacturer is exempt from all
liability regarding any damage caused by unauthorised spare parts or accessories.
- When working on each machine or on the units linked to them, disconnect the unit from the power supply and the
start-up devices, as the electrical parts of the pump are live during operation.
- All assembly and maintenance work must be carried out by qualified and authorised personnel who have carefully
read the installation and service instructions.
- To guarantee safety when operating the machine, you must comply with that set out in the installation and service
instructions.
- In the event of defective operation or faults, contact your supplier or nearest representative.
WARNINGS DURING INSTALLATION AND ASSEMBLY WORK
The equipment should be connected to an alternating current supply (see data on the pump's plate) with earth
connection, protected by a residual current device (RCD) having a rated residual operating current not exceeding
30 mA.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Where the intended use is not as indicated, additional technical adaptations and regulations may be required.
Installation and General Maintenance Manual
) indicate the possibility of danger where the corresponding instructions are not followed.
- FIJI 3