Identification Number; Lock Function - Monacor JTS IN-264TH /5 Manual De Instrucciones

▼
3) Press the button (3) to select the setting
or press the button  (5) to select the setting
4) Press the button SET to confirm The display
briefly shows
the normal mode

5.1.5 Identification number

To enable the REMOSET transmission between the
transmitter and the receiver unit, match their iden-
tification numbers
1) Keep the button SET (4) pressed until the display
briefly shows
mode (group indication starts flashing)
2) Press the button SET repeatedly until the display
shows and the current identification number
( ... or )
3) In the setting range
the button  (3) to search in descending order
or press the button  (5) to search in ascending
order Use the corresponding button to set the
transmitter to the identification number of the
receiver unit (the transmitter will only respond
to the REMOSET signal of this receiver unit) or
select (the transmitter will respond to the
REMOSET signal of any receiver unit)
4) Press the button SET to confirm The display
briefly shows
normal mode

5.1.6 Lock function

When the lock function has been activated, you
will no longer be able to switch off the unit or to
mute the microphone From the setting modes, you
will only be able to activate the mode for the lock
function in order to deactivate the lock When you
press a button, the display will show
Activating the lock
1) Keep the button SET (4) pressed until the display
briefly shows
mode (group indication starts flashing)
2) Press the button SET repeatedly until the display
shows (lock off)
3) To activate the lock, press the button  (5) The
display shows
4) Press the button SET to confirm The display
briefly shows
normal mode
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
The unit will then return to
and then the group setting
, ...
The unit will return to the
(lock on)
and then the group setting
The unit will return to the
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
Deactivating the lock
1) Keep the button SET (4) pressed until
flashing in the indication
2) To deactivate the lock, press the button  (3)
The display shows
3) Press the button SET to confirm The display
briefly shows
normal mode
6 Specifications
Carrier frequency range: 506 – 542 MHz
Frequency stability:
Transmission power:
Audio frequency range: 50 – 16 000 Hz
press
Microphone cartridge:
Ambient temperature:
Power supply:
Operating time:
Dimensions:
Weight:
Subject to technical modification
starts
The unit will return to the
☞ table on page 20
±0 005 %
switchable
10 mW or 50 mW
dynamic / cardioid
0 – 40 °C
2 × 1 5 V battery of
size AA
> 25 h (for alkaline
batteries 3400 mAh)
⌀ 50 mm × 250 mm
350 g (w / o batteries)
11