Power Supply - Monacor JTS IN-264TH /5 Manual De Instrucciones

In the Federal Republic of Germany, the transmitter
requires a frequency assignment (for which a
fee is charged) In other countries, it is necessary
to apply for a corresponding approval Prior to op-
erating the unit outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country Links to the
national authorities can be found via the following
Internet address:
www cept org
t ECC
t Topics
t Other spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
t EFIS and National Frequency Tables
4

Power Supply

For power supply, two 1 5 V batteries of size A A
are required
•
Only insert two batteries of the same type and
always replace both of them
•
If the transmitter is not in use for a longer period
of time, always remove the batteries to prevent
damage due to battery leakage
Never put used batteries in the house-
hold waste; always take them to a special
waste disposal, e g collection container
at your retailer
1) Unscrew the sleeve (6) on the lower end of the
transmitter
2) Slide the cover (7) of the battery compartment
(8) downwards and open it
3) Insert the batteries with the positive and nega-
tive poles as indicated in the battery compart-
ment
4) Close the cover, press it down on the batteries,
then slide it upwards to lock it
5) Screw the sleeve on the transmitter again
5 Operation
1) Before switching on the hand-held transmit-
ter, set the receiver unit to an interference-free
transmission frequency
of the receiver
2) To switch on the transmitter, press the but-
ton / (2) The display (1) shows the group
☞ instruction manual
( ... ), the channel of the group and a bat-
tery symbol indicating the current battery status
in 4 levels:
full
Each time you press a button, the display back-
light will be activated for a few seconds (green
in normal mode)
3) Via the REMOSET function, the transmitter is
automatically set to the transmission frequency
of the receiver unit For correct operation, make
sure that
– the transmitter is not too far away from the
receiver (maximum range of REMOSET trans-
mission: 10 m)
– the automatic frequency matching for the
transmitter has been enabled
– the transmitter and the receiver unit have
been set to the same identification number
☞ chapter 5 1 5
– the transmitter is not locked
Check the settings on the transmitter and cor-
rect them, if necessary Then activate the REMO-
SET function on the receiver unit
manual of the receiver When the frequency is
matched, the display backlight on the transmit-
ter is blue The display briefly shows
the transmitter will be set to the channel and
the channel group of the receiver unit
Manual setting of the channel group and
the channel on the transmitter is also possible
☞
chapter 5 1 1
4) Speak / sing into the microphone The display of
the receiver unit shows the volume level of the
microphone To readjust it, change the sensitivity
☞ chapter 5 1 2
5) To mute the microphone for short interruptions,
press the button
muted, the display backlight is red In this case,
the backlight is not extinguished automatically
but starts flashing after a few seconds
To unmute the microphone, press the but-
ton / once again
6) The transmitter is provided with a lock func-
tion to prevent accidental change of settings
☞
or switching off
7) To switch off the transmitter, keep the button
/ (2) pressed until the display shows
Then the transmitter is switched off
discharged
☞ chapter 5 1 4
☞ chapter 5 1 6
☞ instruction
/ (2) When the sound is
chapter 5 1 6
and
9