Cameo Q-SPOT 40 RGBW Manual De Usuario página 8

SYSTEM SETTINGS (settings)
To access system settings, press the MODE button repeatedly until "Menu DMX Addr" or "Menu Mode" appears in the display. Now select
the menu item "Menu Settings" using the UP and DOWN keys and press ENTER. Now select the desired submenu item, but this time with
the buttons UP and DOWN and confirm with ENTER (see tables, note submenus).
Settings
Display Rev = rotate display by 180°
Display = automatic display
shutdown
DMXFail = operating status with
DMX signal fault
Dim.Curve = dimmer curve
Dimmer Resp. = dimmer sensitivity
White Balance = white balance
IR Remote = activate or deactivate
control by IR remote
control
Factory Reset = reset to factory settings
8
Display Rev On = rotate display by 180° (e.g. for overhead installation)
Display Rev On = normal orientation of the display
Display On = permanently on
Display Off = automatic display shutdown after approximately 1 minute of
inactivity.
Hold = last command is retained
Blackout = activates blackout
Linear = light intensity increases linearly with DMX value
Exp = light intensity can be finely adjusted at lower DMX values and
broadly adjusted at higher DMX values.
Log = light intensity can be broadly adjusted at lower DMX values and
finely adjusted at higher DMX values.
S-Curve = light intensity can be finely adjusted at lower and higher DMX
values and broadly adjusted at medium DMX values.
LED = spotlight responds abruptly to changes in DMX value
Halogen = spotlight behaves like a halogen spotlight with soft brightness
changes
Red, Green, Blue, = individual white balance. Cross-mode
White setting of the 4 LED groups RGBW
On = IR remote control activated
Off = IR remote control deactivated
Reset Now? ENTER = reset to factory setting
MODE = do not perform reset