Rds Button; Mono Button; Dab Radio; Dab Radio Station Playing - Rotel RT-12 Manual De Instrucciones

English
Note: The RDS features are entirely dependent on the broadcaster
sending properly encoded signals. Thus, they will only be available
in markets where RDS is currently implemented and where stations are
broadcasting these data signals.

RDS Button

O
The RDS button on the remote control can step through the various
displays. Press the RDS button on the remote to step through the following
displays.
1. Radio Text
2. PTY, or the type of content.
3. Name of station.
4. Stereo or Mono station.
5. Current time.
6. Today's date.

MONO Button

O
The MONO button on the remote control changes the FM mode from
stereo reception to mono reception. In stereo mode, a stereo signal
will be heard if the station is broadcasting a stereo signal and there is
sufficient signal strength.
Note: Switching to mono mode can be a useful way to improve
the reception of weak or distant FM signals. Less signal strength is
required for clean mono reception than for stereo reception.

DAB RADIO

Make sure that your local area can receive Digital Audio Broadcast
(DAB) broadcasting signal.
Press the DAB button on the front of the panel, or remote
6
DAB channels are categorized into ensembles, which are also known
as multiplexes. Each multiplex provides a number of stations and each
service contains a primary service that can contain secondary services.
DAB technology allow broadcasters to transmit additional data along
with the audio, which can include other audio channels, text and even
images and computer data in the future.

DAB Radio Station Playing

1. Select DAB Button from the front panel and the unit will scan for available
stations. After scanning you will see the following menu.
DAB
<Station list>
Push the PUSH-SELECT knob
=
to see available stations.

Storing a DAB station in a preset

While a DAB station is playing, hold down the memory button
then press the number of preset assigned from numeric pad
to 30 preset DAB radio stations may be stored.

Playing a preset DAB station

When a DAB station is playing, you can switch to a preset station in one
of the following ways.
1. From the numeric pad
station.
2. Press SKIP +/-
remote to call out preset numbers and corresponding station. Turn the
knob to choose the desired station, then press the knob to select, or press
the ENT key on the remote.

DAB Settings Menu

Press the DAB
6
settings Menu. There are 6 sub-menus. Turn the knob on the front panel or
use the UP/DOWN keys on the remote to go through each sub-menu.
1. <Station List>, shows station list.
2. <Full Scan> Start a full range scan by pressing the ENT key.
3. <Manual Scan> Press ENT and select stations manually by using
the Up/Down keys.
4. <DRC> Dynamic Range Control Select between "off", "high" and
"low". Press ENT and select Up/Down keys to change.
5. <Prune> Select between "Yes" or "No". The Prune setting allows you
to remove stations that are not active or can not be received.
6. <System>, Select the Factory Default and show Software Version.
.
N
H , press preset number of the desired
3
button on the front panel or PRESET +/-
7
N on the front panel or remote to toggle to the DAB
15
I ,
4
. Up
3 H
on the
K