Throttle Lever Free Play - Echo HCA-265ES-LW Manual De Instrucciones

Before you start
Cutter assembly position
1. Knob
1. Support notch
2. Blade cover

Throttle lever free play

1. Locknut
2. Adjustment nut
The cutter assembly can be adjusted to ten different positions
ranging from 135° to 270° from the outer tube as shown. Al-
ways make sure the lock latch is securely locked after each
adjustment.
Adjusting for Storage or Transportation
1. With the engine off, install the Blade cover onto the blade.
2. Rotate the cutter assembly so it is parallel to the tube. The
rotation is restricted at the position of 135° by the lock pin.
Pull the knob and release the lock pin.
3. Make sure the latch lock and the latch release return secure-
ly to a locking position.
4. Fit the tip of the cutter assembly into the storage position of
the hand guard and fix it.
5. Make sure the Blade cover is in place on the cutters before
storing or transporting
Never run the engine when adjusting the cutter assem-
bly to the storage position.
The throttle lever free play should be approximately 4-6 mm.
Make sure that the throttle lever operates smoothly without bind-
ing. If it becomes necessary to adjust the lever free play, follow
the procedures and illustrations that follow.
1. Loosen the unscrew fasteners and remove the air cleaner
cover.
2. Loosen the locknut. Turn the adjustment nut in or out as re-
quired to obtain proper free play 4-6 mm.
3. Tighten the locknut.
4. Reinstall the air cleaner cover.
18
WARNING