Hilti TE30 Manual De Instrucciones página 13

7.1.2 Fitting the insert tool 4
1. Disconnect the supply cord plug from the power
outlet.
2. Check that the connection end of the insert tool is
clean and lightly greased. Clean it and grease it if
necessary.
3. Check that the sealing lip of the dust shield is
clean and in good condition. Clean the dust shield if
necessary or replace it if the sealing lip is damaged.
4. Push the insert tool into the chuck and rotate it while
applying slight pressure until it engages in the guide
grooves.
5. Push the insert tool further into the chuck until it is
heard to engage.
6. Check that the insert tool has engaged correctly by
pulling it.
7.1.3 Removing the insert tool 5
CAUTION
Wear protective gloves when changing insert tools as
the insert tools get hot during use.
1. Disconnect the supply cord plug from the power
outlet.
2. Open the chuck by pulling back the chuck release
sleeve.
3. Pull the insert tool out of the chuck.
7.1.4 Removing the chuck 6
CAUTION
Remove the depth gauge from the side handle in order
to avoid injury.
1. Disconnect the supply cord plug from the power
outlet.
2. Pull the chuck sleeve forward and hold it securely.
3. Remove the chuck by pulling it away from the power
tool.
7.1.5 Fitting the chuck 7
CAUTION
Remove the depth gauge from the side handle in order
to avoid injury.
1. Disconnect the supply cord plug from the power
outlet.
2. Grip the chuck sleeve, pull it forward and hold it
securely in this position.
3. Slide the chuck onto the guide tube from the front
and then release the sleeve.
4. Rotate the chuck until it is heard to engage.
7.2 Operation
CAUTION
Working on the material may cause it to splinter. Wear
eye protection and protective gloves. Wear breathing
protection if no dust removal system is used. Splin-
tering material presents a risk of injury to the eyes and
body.
CAUTION
The work generates noise. Wear ear protectors. Expo-
sure to noise can cause hearing loss.
NOTE
The TE 30‑M is equipped with a protective electronic
motor cut-out that is active in 1st gear (rotary-only drilling
and hammer drilling). This cut-out switches the tool off
automatically when motor speed drops below a specified
speed for a long time. After the tool has switched itself
off it can be restarted by briefly releasing the switch and
then pressing it again.
7.2.1 Unlocking the tool (theft protection system –
not available for all versions) 8
NOTE
Further detailed information on activation and use of the
theft protection system can be found in the operating
instructions for the theft protection system.
NOTE
If, for example, the electric supply is briefly interrupted
due to a power failure or disconnected when moving to
a different workplace, the power tool remains ready for
operation for approx. 20 minutes. In the event of a longer
interruption, the TPS key must be used to unlock the
power tool.
1. Plug the supply cord into the power outlet. The
yellow theft protection indicator LED blinks. The
power tool is now ready to receive the signal from
the TPS key.
en
9