Inserting Sd Cards; Camera Connection And Attachment; Connecting Monitors And Headphones - Tascam DR-60DMKII Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51

Inserting SD cards

Open the SD card slot/USB port cover on the
1.
right side of the unit.
Insert the SD Card into the slot as shown in the
2.
following illustration until it clicks into place.
Camera connection and
attachment
In order to output the sound from this unit to a DSLR
camera and monitor sound from the camera with
this unit, you must connect them with commercial-
ly-available 3.5mm stereo mini plug cables.
If you want to record audio from this unit with
1.
a camera, connect the CAMERA OUT (LOW)
jack on the left side of this unit with the external
mic input on the camera.
If you want to input audio from the camera and
monitor it with this unit, connect the CAMERA
IN jack on the left side of this unit with the
audio output jack on the camera.
12
TASCAM DR-60DMKII
Audio
output jack
External mic
input jack
NOTE
• If the output is not loud enough even when
the CAMERA OUT (LOW) volume is set as
high as possible, connect it to the CAMERA
OUT (HIGH)/LINE OUT jack, and use the
CAMERA OUT (HIGH)/LINE OUT volume to
adjust the output level.
• Refer to the camera's operation manual to
identify this connector on the camera.
Use the CAMERA OUT (LOW) volume control
2.
on the left side of the unit to adjust the level
output to the camera.
To mount the camera on this unit, use the
3.
camera attachment screw on the top of the
unit.
Connecting monitors and
DSLR camera
headphones
To listen with headphones, connect them to the
PHONES jack.
To listen with an external monitoring system
(powered monitor speakers or an amplifier and
speakers), connect it to the CAMERA OUT (HIGH)/
LINE OUT jack.
Headphones
Powerd monitor speakers
or amplifer and speakers

Publicidad

Tabla de contenido
loading

Tabla de contenido