Mitsubishi Electric PAC-IF013B-E Para El Instalador página 14

4. Electrical work
<Fig. 4.3.10>
Seal the gap between the cable
and the access hole with putty.
Thread the remote controller cable through the cable
access hole at the top of the remote controller.
<Fig. 4.3.11>
<Fig. 4.3.12>
14
Check that the cover is
securely installed and not
lifted.
Use a cable cover.
9. Fit the top case and the front cover onto the bottom case.
The top case assembly (fitted with the front cover at factory shipment) has two
tabs on top. Hook the tabs onto the bottom case and snap the top case onto the
bottom case into place. Check that the cover is securely installed.
Caution:
When the top case is correctly attached to the bottom case a click is heard. If
the front cover is not clicked into place it may fall off.
■ Direct wall installation (when routing the remote controller cable along the wall
surface)
• Thread the remote controller cable through the cable access hole at the top
of the remote controller.
• Seal the gap between the cable and the access hole with putty.
• Use a cable cover.
●
Disassembling the top case and the front cover
(1) Remove the front cover.
Insert a flat head screwdriver into either of two open slots at the bottom of the
remote controller and move the screwdriver handle downward as shown. The
engagement of the tabs will be released. Then pull the front cover toward the
front to remove the front cover.
(2) Remove the top case.
Insert a flat head screwdriver into either of two open slots at the bottom of the
remote controller. The subsequent procedure is the same as that of the front
cover.
Caution:
Use a 5 mm- flat head screwdriver. Do not turn the screwdriver forcibly while
placing the blade in the slots. Doing so could break the covers.