Powering Your Dvr-1Hd Mini - Snooper DVR-1HD Mini Manual Del Usuario

Powering your DVR-1HD Mini using the car charger
1. Connect the USB plug on the end of the car charger to the USB
DC5V~12V socket on the end of the DVR. Plug the car charger in to a
12V cigarette lighter socket in your vehicle, ensuring that the cable is
not obscuring the driver's view or interfering with any of the driver's
controls.
Caution: use only the car charger supplied with your Snooper DVR-
1HD Mini. Using a different car charger could cause the unit to operate
incorrectly and could damage the unit invalidating the warranty.
Powering your DVR-1HD Mini using the 'hard wire'
lead
You can power your DVR-1HD by wiring it directly to your vehicles 12V
electrical system using the 'Hard Wire' cable supplied as standard with
your unit.
1. Connect the positive side of the cable (marked with a red plus symbol)
to a 12V permanent live. This is a permanent live which has power if
the if ignition if On or Off.
2. Connect the negative side of the lead to a negative ground - any
metal portion of the vehicles frame.
UK • 8