Operation Description; Changing The Batteries - Rheem RXAC Manual De Uso

resulting in reduced power consumption.
After 8 hours, this function is turned off automatically. The function can be turned on
again by pressing the "ECO" button.
NOTE:
The unit will turn off automatically if the timing mode is running out
of time.
19. Two white buttons: Addressing set
With the controller off, pressing the two white button simultaneously 10 seconds or
more to enter addressing setting. This status displays only temperature and time
parameters, temperature display area shows "Serial number" parameters, the range
is 0-99. Time display area shows "Set value" the range is 0-255. The initial value is
1. By pressing "
serial number displays from 0 to 99 in circulation.
By pressing "ECO" and "iCLEAN" to set value number + and -. Parameters within
the value number displays from 0 to 255 in circulation. After setting the two
numbers, press the MODE button to confirm the setting.
"MODE" button
20.
This enables you to select different operation mode, after each pressing, the
operation mode will be changed.
It shows in the following display.

OPERATION DESCRIPTION

CHANGING THE BATTERIES

1. Open the sliding cover in the direction of the arrow.
2. Insert two new batteries (AAA), observing the polarity (+/-).
" or " "to set serial number + and -. Parameters within the