Remote Controller; On Off Button - Whirlpool PACW9COL Instrucciones De Uso

Remote controller

Insert the batteries into RC
1. Insert a pin and gently press down on the battery
cover and push in the direction of the arrow to
remove, as shown.
2. Insert 2 AAA batteries (1.5V) into the compartment.
Ensure that "+" and "-" polarity is correctly positioned.
3. Close the battery cover on the remote control.
• Remote Control presetting
Each time the batteries are replaced in the remote
controller, the remote controller pre-set at Heat Pump
mode. The heat pump AC remote controller can be used
to control the cool only AC models.
• The remote control will operate the air conditioner at
a distance of up to 7m.
Note: please follow the intruction which matches to the remote controller you receive for Air Conditioner
operation.
Function description of buttons

1. ON OFF BUTTON

Starts and/or Stops the appliance by pressing this
button.
2. MODE BUTTON
Used to select the operation mode.
3. FAN BUTTON
Used to select fan speed in sequence auto, high,
medium or low.
4-5. TEMPERATURE BUTTON
Used to select the room temperature. Used to set
time in timer mode and real time clock.
6. 6th SENSE BUTTON
Sets or cancels 6th Sense operation.
7. SWING BUTTON
Stops or starts horizontal adjustment louver
swinging and sets the desired up/down airflow
direction.
8. SLEEP BUTTON
Sets or cancels Sleep Mode operation.
9. AROUND U BUTTON
Used to start or cancel Around U function.
10. JET BUTTON
Used to start or stop the fast cooling or heating.
11. TIMER BUTTON
Used to set or cancel the timer on operation.
Used to set or cancel the timer off operation.
12. DIM BUTTON
Used to turn on or turn off display light on indoor
unit.
Symbols on RC display
Cooling indicator
Dry indicator
Fan only indicator
Heating indicator
Auto fan speed
High fan speed
Medium fan speed
Low fan speed
- 7 -
Use RC to control the appliance
• To operate the appliance by remote control, point the
remote control at the receiving device on the indoor
unit, to ensure receiving sensibility.
• To send a message from remote control, the symbol
will flash for 1 second. On receipt of the message, the
appliance will emit a beep.
Signal receptor
6th Sense indicator
Sleep indicator
Around U indicator
Jet indicator
Signal transmission
Display set timer
Display set temperature