Selection Of Temperature Sensor; Calibration Of Temperature Setting - Zehnder 40019309 Manual De Instrucciones

5.4 Selection of temperature sensor

The temperature of your room can be measured either by the receiver unit under your appliance
or by the remote control.
The default sensor will depend on the type of appliance you have bought.
Appliances labelled NF Électricité Performance use the sensor under the receiver unit
as the default. You are strongly recommended not to alter this setting, which ensures
optimal performance, in accordance with the label for your appliance.
In any case, measuring the ambient temperature from the remote control will provide a better
You can choose your preferred ambient temperature measurement option from parameter 5 of
Advanced parameters (see chapter 5.3).
If you observe a difference between the temperature you have programmed on your remote
control and the temperature measured in your room, this will provide a useful alternative means to
calibrate the temperature measurement (see chapter 5.5).
Measurement
by control unit
If you choose to measure the temperature from the remote control, and the latter should
become faulty (electronic fault or spent batteries), your appliance will show a sensor fault
(yellow LED, see chapter 8.3).
Besides, the battery life will be reduced by using the remote control sensor.
the control into the drawer if it is being used to measure the temperature of your room.
Similarly, a wall-mounted remote control will not measure the room temperature
correctly.
If the remote control is reset (see chapter 5.3, parameter 9), the default active sensor
will revert to the factory settings.
66
Measurement
by appliance
NEVER put
40019121

5.5 Calibration of temperature setting

temperature detected in your room and the temperature programmed on your appliance, you can
Your thermometer must be
placed in the middle of the room,
boost
with no furniture between it and
mode
Access advanced settings (see chapter 5.3). Press the mode
parameter 4.
If the ambient temperature measurement is different from your appliance's temperature setting,
press the - or +
You can calibrate your temperature measurement to +/- 5°C.
To quit advanced parameter setting, press several times on the mode
control stops.
Calibration relates to the two temperature sensors (see chapter 5.4). If the active sensor
changes, the calibration set on the remote control still applies.
boost
mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode
EXAMPLE:
while the temperature setting on your
in parameter 4, press the -
controller displays -2°C.
02/2019
20
15
10
the radiator.
5
boost
mode
20
67