Handling The Remote Controller; Location Of The Remote Controller - Toshiba RAS-M10GDCV-E Manual Del Propietário

HANDLING THE REMOTE CONTROLLER

CAUTION
• The air conditioner will not operate if curtains, doors or other materials are blocking the signals sent
from the remote controller to the indoor unit.
• Prevent any liquid from falling into the remote controller.
Do not spill juice, water or any kinds of liquids.
• If the infrared signal receiver on the switch panel is exposed to direct sunlight, the air conditioner may
not function properly.
Use curtains to prevent reaching the receiver from direct sunlight.
• If the air conditioner is installed in a room which has fluorescent lights with electronic starters or inverter
system, signals may not be properly received and the air conditioner can't start or stop while the lights
go on. If you are planning to use such fluorescent lights in the same room where the air conditioner
operates, consult your local dealer.
• If other electrical appliances react to the remote controller of the air conditioner, either remove these
appliances or consult your local dealer.

Location of the remote controller

• Keep the remote controller where its signals can reach
the receiver on the switch panel.
(maximum distance is 7 m)
• When you select the timer operation, the remote
controller automatically transmits a signal to the indoor
unit at the specified time.
If you keep the remote controller in a position that
hinders proper signal transmission, a time lag of up to
15 minutes may occur.
Remote controller holder
Installing the remote controller holder
• Before you install the remote controller holder on a wall
or pillar, check whether the remote controller signals
can be received by the indoor unit.
Mounting and removing the remote controller
• To mount the remote controller, hold it parallel to the
remote controller holder and push it in fully. To remove
the remote controller, slide the remote controller
upwards and take it out from the holder.
Receiving section of main unit
When the receiving section receives the signal,
a receiving sound is issued from the indoor unit.
pip, pip : Operation
Long pip : Stop
pip : Change
Approx. 7m
ST AR T
AU TO RE
O FF O N
RY
TE M PO RA
TO
CO O L AU
VO LT AG E1
24 0V
30 V
22 0V /2
N
RE M O CO
VO LT AG E2
B
A
23 0V
22 0V
8
AR T
AU TO RE ST
Y
TE MP OR AR OF F ON
CO OL AU TO
Receiving
VO LTA GE 1
24 0V
22 0V /23 0V
RE MO CO N
section of
VO LTA GE 2
B
A
23 0V
22 0V
main unit
Transmitting section
of remote controller