DeWalt D28114 Manual De Instrucciones página 11

4-1/2" (114.3 rnm) and 5" (127 rnm)
Grinding Wheels
Type 27 guard
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Type 27 guard
Type 27 hubbed wheel
Accessories
It is important to choose the correct guards, backing pads and flanges
to use with grinder accessories. See pages 10-12 for information on
choosing the correct accessories.
10
6" (152 turn) Grinding Wheels
Type 27 guard
stamped steel
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Type 27 guard
Type 27 hubbed wheel
WARNING: Accessories must be rated for at least the speed
recommended on the tool warning label Wheels and other
accessories running over rated accessory speed may burst and
cause injury. Threaded accessories must have a 5/8"- 11 hub. Every
unthreaded accessory must have a 7/8" (22.2 mm) arbor hole. If it
does not, it may have been designed for a circular saw and should
not be used. Use only the accessories shown on pages 10-12 of this
manual Accessory ratings must be above listed minimum wheel
speed as shown on tool nameplate.