Declaration Of Conformity - Rivacold FA Serie Manual De Uso

Manufacturer:
Address:
Hereby Rivacold s.r.l. states that the refrigerating unit (FA-FT)as described hereby
conforms with 97/23 CE directive and has undergone the conformity evaluation procedure as follows:
Cat 0 is excluded according to article 3.3
Cat I Module A (internal manufacturing control)
Cat II Module A1 (internal manufacturing control and final test control), TÜV notified body Süddeutschland
Bau und Betrieb gmbh(0036)
It also conforms with the following directives:
98 / 37 CE
89 / 336 CEE
73 / 23 CEE
And has been manufactured by following standards:
EN 60 204- 1
CEI EN 60335-1
CEI EN 60335-1-24
UNI EN 12100 – 1;UNI EN 12100 - 2
EN 378 – 1;prEN 378 – 2
Description of pressure components that may be part of the complete units conformity evaluation procedures in use:
Description
Compressor
Liquid receiver
Pressure relief valve
Safety pressure switch
Oil separator / Oil
reserve
Liquid separator
Plate-type heat
exchanger
Cartridge filters
Manifolds
Piping
The category of the assembly "shall be determined by the highest category applicable to the equipment concerned
other than that applicable to any safety accessories" 97/23 EC art. 10 §2.b
Rev. 16 Alceste Vitri

DECLARATION OF CONFORMITY

In conformity with the VII enclosure of 97/23 CE directive
RIVACOLD S.r.l.
Via Sicilia 7, 61020 Montecchio (PU), Italy.
Electro-magnetic Compatibility
Machinery safety – Machine electrical equipment
Electrical device safety
Electrical device safety
Machinery safety
Refrigerating equipment and heat pumps – safety and
environmental requirements
art.3.3
Module A
Module A
Module A
Module A
Module A
DN≤35mm Module A
DN≤35mm 35≤DN≤108
Managing Director
Machine Directive
Low Tension
Evaluation procedure
CAT I CAT II
Module D1
Module D1
-
-
Module D1/A1
Module D1/A1
Module B+D
Module D1
Module A1
CAT III
-
Module B1+D Module B+D
-
- Module B+D
Module B1+D
-
-
Module B+C1
BLOCKSYSTEM FA-FT Pag. 87
CAT IV
-
Module
G/B+D
-
-
-
REV. 04 10/07