Proper And Improper Use Of The Partly Completed Machinery; Declaration Of Incorporation - Rivacold CO2NNEXT Instrucciones Para El Ensamblaje

rev.00

Proper and improper use of the partly completed machinery

The partly completed machinery that is the subject of these assembly instructions has been
designed and built exclusively for the sole refrigeration of refrigeration cabinets. The partly
completed machinery, depending on its identification code, is configured to use refrigerant gas
R404A / R134a or, alternatively, propane R290. We specify that each individual partly completed
machinery is designed to use only one of the two gases mentioned above. It is therefore important
to use the partly completed machinery with the refrigerant fluid for which it has been designed and
manufactured, and with the configuration t has been received with from the Manufacturer.
The partly completed machinery has been designed and built to work in environments that do not
have a potentially explosive atmosphere.
The partly completed machinery must be adequately protected against atmospheric agents.
It is a sound cautionary norm to place powder extinguishers near the partly completed machinery.
To prevent the possibility of a fire outbreak, it is necessary to keep the partly completed machinery
clean of pieces of plastic, oils, solvents, paper, and rags.
The use of the partly completed machinery for different operations could cause damages to
persons or to the partly completed machinery itself and such operations are therefore considered
improper uses for which the Manufacturer does not deem itself responsible.
CAUTION: in case of a different intended use, it is essential to first consult the
Technical Office of the Manufacturer.

Declaration of incorporation

This document is complete with the Declaration of Incorporation, which will be issued by the
manufacturer at the time of purchase.
Co2Nnext
EN
49 / 168