Radio - Kenwood KDC-BT365U Manual De Instrucciones

RADIO

Search for a station
1
Press repeatedly to select TUNER.
2
Press repeatedly (or press
select FM1/ FM2/ FM3/ AM.
3 Press S / T (or press S /
station.
• To change the searching method for S / T: Press
repeatedly.
AUTO1 : Automatically search for a station.
AUTO2 : Search for a preset station.
MANUAL : Manually search for a station.
• To store a station: Press and hold one of the number buttons (1 to 6).
• To select a stored station: Press one of the number buttons (1 to 6) (or
press one of the number buttons (1 to 6) on RC-406).
Direct Access Tuning (using RC-406)
1
Press DIRECT to enter Direct Access Tuning.
2
Press the number buttons to enter a frequency.
3
Press to search for a station.
• To cancel, press or DIRECT.
• If no operation is done for 10 seconds after step
is automatically canceled.
6
/ on RC-406) to
on RC-406) to search for a
2 , Direct Access Tuning
Other settings
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press and hold to exit.
To return to the previous setting item, press
TUNER SETTING
AUTO YES: Automatically starts memorizing 6 stations with good reception. ;
MEMORY NO: Cancels.
• Selectable only if [NORMAL] is selected for [PRESET TYPE]. ( 5)
MONO SET ON: Improves the FM reception, but the stereo effect may be lost. ;
OFF: Cancels.
NEWS SET
(For
ON: The unit will temporarily switch to News Programme if available. ;
OFF: Cancels.
REGIONAL
(For
ON: Switches to another station only in the specific region using the "AF"
control. ; OFF: Cancels.
AF SET
(For
ON: Automatically searches for another station broadcasting the same
program in the same Radio Data System network with better reception
when the current reception is poor. ; OFF: Cancels.
TI ON: Allows the unit to temporarily switch to Traffic Information if available
("TI" lights up). ; OFF: Cancels.
PTY SEARCH Select the available Program Type ( 7), then, press S / T to start.
.
Default: XX
)
)
)