Activating/Deactivating The Alarm - Hama RC 540 Instrucciones De Uso

4.3. Alarm
Setting the alarm time
• Press and hold the ALARM button (3) for approx. 2 seconds until the hours display
(B – 9) begins to flash.
• Set the following information in the order listed:
• Hours
Alarm time (B – 9)
• Minutes
• To select the individual values, press the
confirm your selection by pressing the ALARM button (3).
• If you do not make an entry for 30 seconds, the device automatically exits the
settings mode and the settings you made are saved.
• Press the ALARM button (3) to display the set alarm time for approx. 5 seconds.

Activating/deactivating the alarm

• Move the ALARM ON/OFF slide switch (11) to the left to the ON position. A red
surface will be visible underneath the slide switch.
• The alarm is activated and the alarm clock icon (B – 11) is shown on the display (1).
• Move the ALARM ON/OFF slide switch (11) to the OFF position to the right until
the surface underneath the slide switch is black.
• The alarm is deactivated and the alarm clock icon (B – 11) disappears from the
display (1).
Stopping the alarm/snooze function
• If the alarm is activated, it is triggered at the set time and an alarm signal sounds
for one minute. The alarm automatically stops after this time and is then triggered
again the next day at the set alarm time.
• To stop the alarm early, move the ALARM ON/OFF slide switch (11) to the OFF
position to the right until the surface underneath the slide switch is black. The alarm
is now deactivated.
• Move the ALARM ON/OFF slide switch (11) back to the ON position on the left
again to activate the alarm for the next day.
button (4) or the button (5) and
7