Replacing The Batteries - Hama RC 540 Instrucciones De Uso

Note – Snooze function
• While the alarm signal is sounding, press the SNOOZE/LIGHT button (6) to
activate the snooze function. The alarm clock icon (B – 11) on the display (1)
begins to flash. The alarm signal will be stopped for 5 minutes, after which it
will sound again.
• The snooze function can be activated four consecutive times.
4.4. Temperature display
• Press the RCC button (10), to switch the temperature display (B – 6) between °C
and °F.
4.5. Backlight
• If you press the SNOOZE/LIGHT button (6), the display (1) will light up for approx.
5 seconds.
• The alarm clock is equipped with a twilight sensor (7) that automatically switches
on the backlight of the display (1) to a dimmed setting as soon as it gets dark.
• During the day or if there is enough light, the twilight sensor (7) automatically
switches off the dimmed backlight on the display (1).
• Move the ON/OFF slide switch (8) to the ON or OFF position to activate or
deactivate the twilight sensor (7).
Note – Backlight
• We recommend deactivating the twilight sensor while the clock is not in use,
while it is packed during travel, etc.
• Continuous use of the twilight sensor will drain the battery.

4.6. Replacing the batteries

• Once the elements on the display (1) begin to dim, replace the batteries as
described in 3. Getting Started.
5. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or from
failure to observe the operating instructions and/or safety notes.
8