Audio Playback (Via Bluetooth ® ); Hands-Free Function; Sound Mode - Hama 00173163 Instrucciones De Uso

• Switch on the speakers as described in 4.1 Switching the product on and off.
• After successful connection, the status LED (4) will light up in blue. An acoustic
signal confirms that connection was successful.
Note – Connection impaired
• After the speaker and terminal device have been paired, a connection is
established automatically. If the Bluetooth
automatically, check the following:
• Check the Bluetooth
Soundcup-L is connected. If not, repeat the steps listed under Bluetooth
pairing.
• Check whether your terminal device and the speaker are less than 10 metres
apart. If not, move them closer together.
• Check whether obstacles are impairing the range. If so, move the devices closer
together.
• Check whether the audio cable is connected to the speaker. If so, disconnect it.
4.6 Audio playback (via Bluetooth
Start and control audio playback on the connected terminal device accordingly.
Alternatively, audio playback can also be controlled on the speaker (if the connected
device supports this function).
• Press the function button (1) to start or pause audio playback.
• Swipe from left to right or right to left on the touchpad to go to the next or previous
track.
• Turn the rotary control to the left or right to increase or decrease the volume.

4.7 Hands-free function

You can use the speaker as a hands-free set for your mobile phone. For this function,
the mobile phone must be connected to the speaker via Bluetooth
• Press the function button
• Press the button (1) twice to reject the incoming call.
Note – Call quality
To increase the call quality, make sure that you are near the speaker with your
mobile phone during the call.

4.8 Sound mode

The 'Sound mode' button (8) enables optimum adjustment of the sound to suit the
requirements both indoors and outdoors. Pressing the button will change the sound
mode; the active mode (Indoor/Outdoor) is displayed on the sound mode status LED
(5).
6
settings of your terminal device to see whether Hama
®
)
®
(1) once to answer an incoming call.
connection is not established
®
®
.
®