System Settings - Velleman CCTVPROM7 Manual Del Usuario

Motion schedule
PTZ (Pan Tilt Zoom)
PTZ controls
Log management

System settings

14/07/2010
CCTVPROM7
• Select the channel for which to schedule motion
recording.
• The grid is divided into 24 hours (horizontal) and 7
week days (vertical). E.g. when the 4
second row is selected (red) than the indicated channel
will be recorded when motion is detected every Tuesday
from 3AM until 4AM.
• Click on 'APPLY TO' to apply the setting to the
indicated channel. Select a different channel to apply
the same settings to that channel.
• When finished, click OK to save or CANCEL to exit
without saving.
• Select the video channel to set-up.
• Set the PTZ communication address (00~99).
• Select the PTZ protocol: Pelco-D, Pelco-P, B01, Samsung etc. ....
• Select the baud rate: 1200, 2400, 4800, 9600, 19200, 38400, 57600
or 115200.
• Click on 'APPLY TO' to apply the setting to the indicated channel.
Select a different channel to apply the same settings to that channel.
• When finished, click OK to save or CANCEL to exit without saving.
• Select the video channel.
• Select Direction, Focus, Zoom, Iris or Automatic.
Depending on the selection options change.
• Use the Up/Down/Left/Right buttons to move the
camera.
• Set the speed of the camera: slow, normal or fast.
• Select the type of log: Operation or Alarms
• Set start and end date and time for the search function.
• Click on SEARCH. An overview of all logs is shown.
• Use the PREV and NEXT buttons to scroll through the
pages. CANCEL to return to the previous menu.
• Press CANCEL again to exit log management.
• There are 6 submenus:
o Configure
o Password
o Date&Time
o Default
o Reset
o About
8
th
square on the
©Velleman nv