Preliminary Settings - Velleman CCTVPROM11 Guía Rápida

Ocultar thumbs Ver también para CCTVPROM11:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Connect the DVR to a local network by plugging a network cable into the LAN port at the back of the DVR.
Connector type is 8P8C (RJ45). Setup is done through the OSD.

7. Preliminary settings

Make sure the connected cameras are on and set the power switch at the rear of the device to the on-
position. It takes about 15 to 30 seconds to start up.
Menu overview
Press the MENU button and enter the password to go into the menu list.
Note: default admin password is "0000" (4 times zero).
QUICK START
DATE SETUP
SYSTEM
EVENT
INFORMATION
ADVANCED
CONFIG
SCHEDULE
SETTING
For more details, refer to the full user manual.
Setting date and time
Before using the DVR the time and date should be set to get a valid time stamp.
Press the MENU button and enter the admin password to go into the menu list.
Select the QUICK START menu item with the
Move to the TIME SETUP menu item. Select it to set date and time.
Note: once recording started, do not change date or time as this will make it very difficult to find back the
recorded files.
Note: when using the DVR for the first time and the correct time is set, leave it on for at least 48 hours.
Password setting
Press the MENU button and enter the password to go into the menu list.
Select the SYSTEM menu item.
Go to TOOLS, select ADMIN PASSWORD (or OPERATOR PASSWORD) and press the ENTER button to set the
password.
Note: an operator can not access the main menu, only the quick menu bar (see below).
Press the cursor up ( ) or down ( ) button to select the value of the first number and press enter to save
and go to the next character, or use the mouse to select the desired value. Repeat this for all four password
numbers.
Note: default admin password is "0000" (4 times zero).
Record settings
Press the MENU button and enter the password to go into the menu list.
Select the QUICK START menu item using the
Select the GENERAL menu item.
Set the image quality and images per second for recording.
Refer to the full user manual on the included CD-ROM for more details.
Audio playback
Press the SLOW and ZOOM button simultaneously to select the desired audio channel or use the quick menu
bar (see below). The current audio channel is indicated in the status bar.
V. 03 - 17/01/2012
CCTVPROM11
GENERAL - TIME SETUP
DATE INFO - DAYLIGHT
TOOLS - SYSTEM INFO
QUICK SEARCH - EVENT SEARCH - HDD INFO - EVENT LOG
CAMERA – DETECTION – ALERT – NETWORK – SNTP – DISPLAY – RECORD -
REMOTE
RECORD - DETECTION
,
,
or
,
,
7
buttons.
or
buttons.
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido