Olympus PT-E06 Manual De Instrucciones página 37

Install the Waterproof Port
To enable the Case to be used underwater, the separately available Waterproof Port for the camera lens
must be installed on the Case. Align the Waterproof Port with the position where the camera lens will be
when the camera is loaded in the Case.
• Refer to the instruction manual provided with the Waterproof Port before attaching the Waterproof Port
to the Case.
• Apply the provided Silicon grease to the O-ring section of the Waterproof Port and the Waterproof Port
mounting thread on the Case.
• Screw the Waterproof Port into the Case by turning it clockwise all the way.
Waterproof Port mount thread
CAUTION:
The Case should not be used underwater at depths that exceed 40 meters. Even when the attached
underwater lens port or other equipment is able to withstand depths exceeding 40 meters, the Case itself
cannot be used at depths of more than 40 meters.
Attach the hand strap
Attach the hand strap to the Case.
Hand strap
Silicon grease
Hand strap ring
En
EN 8