Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the unit in the dashboard
Before installing, make sure the catches on both
sides of the bracket are bent inwards 2 mm (
in). When mounting in a Japanese car, see
"Mounting the unit in a Japanese car" (page 20).
1
Position the bracket inside the
dashboard, then bend the claws outward
for a tight fit.
2
Mount the unit onto the bracket , then
attach the protection collar .
Notes
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
20
GB
182 mm (7
1
/
53 mm (2
1
/
in)
8
Catch
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
3
/
Sony dealer.
32
TOYOTA
in)
4
Bracket
Existing parts supplied with
your car
NISSAN
Bracket
Existing parts supplied with
your car
Note
To prevent malfunction, install only with the supplied
screws .
Detaching and attaching the front panel
For details, see "Detaching the Front Panel"
(page 5).
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
to dashboard/center console
Bracket
to dashboard/center console
Bracket
Fuse (10 A)
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
