Wheel Assembly - RotoZip RFS1000 Instrucciones De Funcionamiento Y Seguridad

BM 2610008432 08-10:BM 2610008432 07-10 7/29/10 10:08 AM Page 11

WHEEL ASSEMBLy

Use only diamond cut-off
W RNING
(type 1) wheels or Rotozip®
XWHEELS™. Bonded abrasive wheels may
burst, causing fragments to fly away at great
velocity possibly striking you or bystanders.
Always use included guard
W RNING
and guard cover when
cutting.
Disconnect tool from power source. Be sure
that wheel guard is in place for cutting.
ROTOZIP® BRAND CUT-OFF WHEELS
Thread backing flange onto spindle, then
place standard lock nut on spindle (Fig. 4).
Tighten standard lock nut using the included
spanner wrench while holding the spindle
lock. Standard lock nut becomes backing
flange for Rotozip® cut-off wheels.
FIG. 4
ST ND RD
LOCK NUT
SPINDLE
B CKING
FL NGE
FIG. 5
SPINDLE LOCK
Place wheel on standard lock nut, making
sure to center wheel on lock nut.
Thread on Rotozip® washer and lock bolt
and tighten using included hex wrench while
holding the spindle lock (Fig. 4 & 5).
If performing a standard cut-off, attach guard
cover and rotate counter-clockwise to lock
into place. If performing a flush cut, do not
attach the guard cover (Fig. 6).
TO REMOVE: Reverse procedure.
STANDARD 4" TyPE 1 DIAMOND WHEELS
Thread backing flange onto spindle, then place
wheel onto spindle.
Thread standard lock nut onto spindle and
tighten using the included spanner wrench
while holding the spindle lock.
Store your Rotozip® lock nut by threading it
onto the included spanner wrench.
W SHER
ZIP WHEEL
GU RD COVER
-11-
XWHEEL
LOCK
BOLT
FIG. 6