Bresser 70-09993 Manual De Uso página 18

FIRST OPERATION OF THE
THERMO-HYGROMETER
1. Open the battery compartment cover on the
back of the Thermo-Hygrometer.
2. Set the desired channel with the switch (D). If
you are using only one transmitter, please leave
the selection at „1".
3. Insert 2 new UM-3 or „AA" 1.5V batteries
observing correct polarity.
4. Use a pin to press the „RESET" - button located
in the battery compartment.
5. Close the battery compartment cover and set
the unit in the desired location.
PLACEMENT TIPS:
Please observe the following guidelines to ensure
optimal operation of the device:
1. Assign each remote unit to it's own channel.
2. Place the receiver unit (Weather station) and re-
mote unit (thermo-hygro sensor) within 1 meter
to each other and enable the manual search for
available signals of all remote units on the main
unit (Weather station, not included) Do this by
pressing the [▼] button on the back side of
your weather station. Wait until the measured
value appears on the display.
- 18 -