Maintenance And Service; Surface Cleaning; Filter Cleaning - Hkoenig KOL7812 Manual De Usuario

MULTIPLE PROTECTION FUNCTIONS
1. Anti-frozen protection function
Under COOL mode, when the compressor continuously runs over 10 minutes, if tube
temperature is ≦2℃/36℉ for 20 seconds, the anti-frozen protection function will be on, E4 will
be shown on LCD display, compressor and water wheel motor will stop working, but upper fan
remains running; If tube temperature≧8℃/46℉, the unit will stop anti-frozen protection and
recover to the original working condition. Compressor will re-start working with 3 minutes delay
for protection.
2. Water-full safety alarm and shut –off protection function
When the water volume exceeds its alarm level in chassis, warning sounds automatically and
water-full icon is lighting in LCD display, you need to drain the condensate and re-start the
unit.(For more information about how to drain, refer to the "Drainage Instruction" please). If the
unit is not shut down manually, the unit will recover to the original operating status automatically
once the water is fully drained. Or connect the power to re-start the unit again.
3. Delay protection function of compressor
This unit offers restart protection to compressor. Except that the compressor may start
immediately when the unit is energized first time, there is 3-minute delay re-start protection after
compressor is shut down.

MAINTENANCE AND SERVICE

Note: Be sure to turn off the unit and pull out the plug
before maintain or send to service center.

1. Surface cleaning

1) Clean the unit surface with wet soft cloth and do not use
chemical solvents such as alcohol and gasoline to avoid
any damage to unit.
2) Clean the dirty air outlet or louvers with wet soft cloth and
detergent.
3) Any chemical solvent is prohibited to use for unit cleaning
or put such things near the unit for a long time.
4) Any thinner, alcohol-glazer or other similar solvents is
prohibited for unit cleaning.

2. Filter cleaning

Clean the filter once every two weeks, or it would
influence the unit function if filter clogged with dust.
1) How to clean filter
A. Grip the filter handle and pull it out gently in correct
direction.