Miele professional HM 29-175 Instrucciones De Manejo página 5

Warning and safety instructions
Notes on the use of this machine
This ironer must be operated at all times
in accordance with the legal requirements
of the Health and Safety Acts.
Please allow only trained persons,
thoroughly familiar with the ironer, to work
at the feed-in. Always conform to local and
national regulations on minimum age require-
ments of operators.
Persons with especially slim fingers
should only work at the receiving side and
not at the feed-in.
When working with the ironer, always
wear close fitting clothes. Wide sleeves,
apron bands, ties or scarves could be taken
in by the roller. Also remove rings or bracelets
before starting to work.
Smooth out folds as far away as possible
from the feed-in on the feed-in table. Feed
pillow cases and duvet covers into the ironer
with the open part first. Do not take hold of
the corners from the inside. Do not take hold
of undershirt and apron straps from the inside.
Always check the proper setting of safety
devices. This way you will avoid the
danger of burns, squashed fingers and even
loss of hands.
Check daily whether the safety devices
function properly.
Make sure that the safety bars cannot be
bridged.
Before switching to reverse make sure
that nobody is endangered.
When using a gas heated system, make
sure that the ventilation of the work room
is sufficient.
Lubricate machine parts only when the
machine is shut off.
It is imperative that all local and national
safety regulations concerning the use of
this machine are observed.
5 M.-Nr. 05372840