General Safety Rules; Diagrama Electrico - Skymsen SI-315HD-1 Manual De Instrucciones

Acid solutions, salty solutions, disinfectants and some sterilizing solutions
( hypochlorite s, tetravalent ammonia salts, iodine compounds, nitric acid and others),
must be AVOIDED, once it cannot remain for long in contact with the stainless steel:
These substances attack the stainless steel due to the CHLORINE on its composition,
causing corrosion spots (pitting).
Even detergents used in domestic cleaning must not remain in contact with the
stainless steel longer than the necessary, being mandatory to remove it with plain water and then
dry the surface completely.
Use of abrasives:
Sponges or steel wool and carbon steel brushes, besides scratching the surface and
compromising the stainless steel protection, leave particles that rust and react contaminating the
stainless steel. That is why such products must not be used for cleaning and sanitization.
Scrapings made with sharp instruments or similar must also be avoided.
Main substances that cause stainless steel corrosion:
Dust, grease, acid solutions such as vinegar, fruit juices, etc., saltern solutions (brine),
blood, detergents (except for the neutral ones), common steel particles, residue of sponges or
common steel wool, and also other abrasives.

4. GENERAL SAFETY RULES

If any item from the GENERAL SAFETY NOTIONS section is not applicable to
your product, please disregard it.
These Safety Rules were made to orient and to instruct the users of the Saw,
and the people who will be responsible for its maintenance.
The Saw shall only be delivered to the user in good use conditions, and the
user shall be instructed by the dealer, about how to use safely the Saw.
The user shall only operate the Saw after complete knowledgement of the
cares to be taken, after reading carefully the present Instructions Manual.
IMPORTANT
IMPORTANT
07
* Ruidos anormales * Hoja patinando sobre los
Volantes
* H o j a
incorrectamente
*Hoja se rompe a menudo * Hoja o Volantes sucios
* Volantes desfectuosos
* Dificultad en el corte del * Hoja o Volantes sucios
producto
* Hoja mal calibrada
* Hoja descentralizada
* Hoja sin corte

5.3 Diagrama Electrico

* Gire la Manija Nº01 (Fig.01) para
aumentar la presión entre la Hoja y los
Volantes, conforme descrito en 5.2.2
s o l d a d a * Cambie la Hoja
* Haga limpieza conforme descrito
en 3.2
* Cambie los Volantes
* Haga limpieza conforme descrito en
3.2
* Haga la calibración de la Hoja
conforme descrito en 5.2.2
* Haga el ajuste del Volante Superior
conforme descrito en 5.2.5, o en casos
más graves, llame a su Revendedor
* Cambie la Hoja
Llave Prende/ Desliga
Contactora
Botón de Emergencia
28