Operation Fundamentals Practices - Skymsen SI-315HD-1 Manual De Instrucciones

Figura - 03
01 02
Tabla - 02
Problemas
* La maquina no se prende. * L a m a q u i n a e s t á
d e s c o n e c t a d a d e l a r e d
eléctrica.
* Botón de Emergencia
trabado
* Falta de Energía Eléctrica
* Problema con el circuito
Interno o Externo de la
maquina
* Olor de quemado o humo * Problema con el circuito
Interno o Externo de la
maquina
* La maquina se prende, pero
* Correa patinando
cuando el producto entra en
contacto con la Hoja Nº08
(Fig.01), la misma para o gira
en baja rotación
* Capacitor de partida del
motor defectuoso
Figura - 04
01
Soluciones
Causas
* Ligue el cable eléctrico de la
maquina en la red eléctrica
* Destrabar el Botón de
Emergencia
* Averigüe si hay energía
eléctrica
* Llame a su Revendedor
* Llame a su Revendedor
* Ajuste la tensión de la correa
de acuerdo con el ítem 5.2.1
* Llame a su Revendedor
27
4.1 Operation Fundamental Practices
4.1.1 Dangers
Some of the electric parts commands have points or terminals with high
voltages. Those when touched may cause electric shock, and even DEATH.
Never touch a manual electric command (button, switch, etc) with wet hands,
02
clothes or shoes. To not observe such recommendation may also cause electric shock, and even
Death.
4.1.2 Warnings
The On/Off Switch position shall be well known, to allow at any moment a fast
switching, without the necessity to look for the Switch.
Before any maintenance, take away the cord plug from the electricity
network socket.
Have enough working space around the Saw to avoid dangerous falls.
Water or oil may turn the floor slippery and dangerous. To avoid accidents
keep the floor dry and clean.
Never inadvertently touch or operate a manual command (button, switch,
etc).
If any kind of work has to be done by two or more people, coordination signals
shall be accorded for each step of the work. The next step shall not be started unless the signal is
given and acknowledged.
4.1.3 Notices
In case of an electric energy supply failure, switch off the On/Off Switch.
Avoid mechanical shocks, since they may cause failures or wrongs to the saw
good operation.
Avoid water, dirt or dust inside the mechanical or electrical components.
DO NOT ALTER the saw original characteristics.
DO NOT SOIL, TEAR OR REMOVE, ANY SAFETY OR
IDENTIFICATION LABEL. If a label is illegible or lost, ask your Technical Assistant to supply
a new one.
08