Warnings For Use - AUtec Modular Serie Manual De Usuario

LIMKNPU2
4

WARNINGS FOR USE

!
THE OPERATOR
MUST ALWA YS
VISUALLY FOLLOW all movements of the machine and its load
remaining inside radio remote control typical working range.
BE POSITIONED in a way that permits him to see the
"machine + radio remote control" system, and above all the load, in the
best possible way.
Before using the radio remote control ALWAYS MAKE SURE that the
STOP push-button can be pressed and released: if it does not work, do
not use the radio remote control.
SWITCH OFF the transmitting unit when work is interrupted. Avoid
leaving the load suspended in the air (even when changing the battery).
NEVER LEAVE the transmitting unit unguarded when the starting
keyswitch is inserted.
ONLY SWITCH ON OR USE the transmitting unit when starting work:
improper use could be hazardous.
NEVER SWITCH ON OR USE the transmitting unit in closed spaces, with
the machine not in sight, or outside the typical working range.
PRESS immediately the STOP button in case of hazard.
PAY ATTENTION to the entire work area. Press the STOP button in case
of hazard.
PAY ATTENTION not to let elements such as cement, sand, lime, etc.
deposit on the transmitting unit because they can compromise
transmitting unit use and safety.
In case of malfunctions and/or damaged and/or faulty parts, PUT the
radio remote control out of use until the problem has been completely
eliminated.
Page 8