Mk10, Mk12 Transmitting Unit Diagnostic - AUtec Modular Serie Manual De Usuario

LIMKNPU2
MK10, MK12 TRANSMITTING UNIT DIAGNOSTICS
If the "machine+radio remote control" system does not start, check if the problem is caused
by the radio remote control or the machine. Before carrying out any verifications, check the
functioning of the machine with the cable control panel:
- if it does not switch on, the problem lies with the machine itself
- if it does switch on, the problem lies with the radio remote control. In this case, proceed as
follows:
When START is
activated, is the red
LED lit steadily
and does the buzzer
sound?
NO
Does the red LED
blink and does
the buzzer sound?
NO
Does the green LED
blink?
NO
If the problem
persists
CALL
TECHNICAL
ASSISTANCE
Is the STOP
button or one
YES
of the movement
actuator inserted?
Release it/them
The battery is
discharged:
replace it with one
YES
that is charged.
Does the LED
continue flashing
and the buzzer
sounding?
NO
Carry out
YES
diagnostics
checks on the
receiving unit.
9
Clean the contacts
in the battery seat.
YES
Is the led on with
a steady light?
NO
Does the LED
continue flashing
and the buzzer
sounding?
NO
YES
YES
Page 14