Fixing Outgoing Conductors; Fixing Conductors With Cable Terminal - M Type Bolt Clamp; Mounting Of Conductors With Bare Terminal - S Type Bridge Clamp - WEG FSW 630 Serie Manual De Instrucciones

www.weg.net

3. FIXING OUTGOING CONDUCTORS

3.1. FIXING CONDUCTORS WITH CABLE TERMINAL - M TYPE BOLT
CLAMP
Take off the cover (acc. to point 3).
Take off the shields for terminals (acc. to point 5).
Fix the conductor with M12 screw and torque 20 Nm (figure 11).
The screw kit is compound by 12 M5 screw and 6 clips type S.
The screw kit is compound by 12 M8 screw and 6 clips type S. Getting the customer's
discretion to use the M12 screw.
3.2. MOUNTING OF CONDUCTORS WITH BARE TERMINAL - S TYPE
BRIDGE CLAMP
Take off the cover (acc. to point 3).
Take off the shields for terminals (acc. to point 5).
Fix the conductors with (M8 bolts, 10 Nm) (Picture 12).
Mount the shields for terminals (acc. to point 6).
Mount the cover (acc. to point 4).
14 Instruction manual for mounting and service of fuse switch disconnectors
Picture 11
Picture 12