Descargar Imprimir esta página

Miele professional MF 02 Instrucciones De Montaje página 28

Módulo 2 dosificación líquida 7-12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Produktgruppe 512
28 von 30
Note
Installation kit mat. no. 09885130 for PW 6241, PW 6321 contains:
1 EZL 230(a) electronic, module 2 (liquid dispensing 7-12)
1 EV 230 adapter
1 electronics bracket
8 spacers (for securing the EZL 230(a) electronic)
1 coded plug MFM 2-5 AWG
1 wiring harness 48X-41X AWG
1 wiring harness 49X-46X AWG
1 wiring harness 51X-52X-101X AWG20
1 wiring harness 47X-100X AWG20
1 green yellow wire 240x96 AWG18
1 accessory module
1 wiring diagram module 2, mat. no. 09021420
1 wiring diagram mat. no. 09882800
These instructions.
List of illustrations:
Fig. 1, Installing cable feed-throughs on the connection strip
Fig. 2, Installing the EZL 230(a) electronic
Disconnect the machine from the electrical supply and gas supply (if applicable) and ensure that power cannot be switched on again
in error.
Remove the left and right screws from the machine lid.
Pull the lid slightly forward, push it back and unhook it from the connection strip.
Remove the lid.
Install the EZL 230(a) electronic, EV 230 adapter (Fig. 2) and cable feed-throughs (Fig. 1).
Wire the EZL 230(a) electronic and EV 230 adapter (Fig. 2) in accordance with the wiring diagram.
Connect electronic EZL 230 46X from electronic 2N1L to 3N1L.
Arrange and connect the wiring harnesses:
Warning!
The load and control current wiring harnesses should be separated from one another to prevent noise in the control circuit
(electromagnetic tolerance).
Extra wiring should be laid in the opposite direction to avoid antenna-like behavior.
Install the coded plug:
Install coded plug MFM 2-5 on module 2 (liquid dispensing 7-12) EZL 230(a)
Register module 2 liquid dispensing 7-12:
Service Settings Register module EZL with coding 2 Register module? OK Diskette symbol to save the registration.
Switch on dispensing display.
Service Settings Basic settings Dispensing Dispensing display: Off
symbol to save display activation.
Note
Switching on the dispensing display enables the operator to select and deselect dispensing. Without dispensing display, only
information regarding whether dispensing is active and the dispensing amount is shown.
To quit service mode, switch the machine off.
06.02.2014
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 06572532
42X, pins 2-5.
On OK Back (to go back one level) Diskette

Publicidad

loading