Numark HDX Manual De Referencia página 9

31. Reloop - Repeats play or "stutters" (if repeatedly tapped) from the "loop in" point.
previously been set, it plays and repeats that loop, until the loop is released by pressing the LOOP OUT
button.
32. Smart Loop – Allows the Beatkeeper™ and loop buttons to work together to create loops that are
synchronized to the beat. First, properly align the Beatkeeper™ to the beat. After this has been done,
all loop points and stuttering will be synchronized perfectly to the beat of the music.
33. Trim – Allows the loop-in and loop-out points to be adjusted. To adjust a point, press TRIM followed by
the button of the point you wish to adjust (LOOP IN, LOOP OUT, RELOOP), then rotate the small jog
wheel. When used with "Reloop" the unit will shift the entire loop by moving both the loop-in and loop-
out points at the same time.
increments.
34. < shift > – Adjusts the loop length by half length or double length increments. If the "Smart Loop"
feature is on, this will be limited to a minimum loop length of 1 beat.
35. Length LEDs – Shows the length of the loop based upon the Beatkeeper™ setting. The middle LED is 4
beats.
Effect Buttons 36-40 are used to activate and deactivate a desired Effect. Holding an Effect button for 1
second will place the effect into a "hold" or alternate effect mode depending on which button you press. Once
an effect is active, rotate the jog wheel to get the desired effect sound. The parameter value will be shown on
the display. You can preset a desired value by holding the button and rotating the wheel.
36. Sonar – Creates a metallic hollow effect to the audio. Pressing and holding this button will keep the
sound from automatically returning to normal when movement of the jog wheel stops.
button will turn the effect on and off at the desired setting.
37. Slide - Smoothly changes the key of the music. In the key display you will see the key change as the
jog wheel is moved. Pressing and holding this button will keep the sound from automatically returning to
normal when movement of the jog wheel stops. Tapping the button will turn the effect on and off at the
desired setting.
38. Echo - Adds echo to the music also based upon tempo
reading of the Beatkeeper™.
echo "0". If you move the wheel clockwise, the numbers
will go 1-64, 1-32, 1-16, 1-8, 1-4, 1-2, and 1-1 indicating
the amount of echo added to the audio. If you move the
wheel counter-clockwise
preceding echo.
the music. At 1-1 the music will echo 1 full measure or 4
beats of music. If you turn off the effect then back on
again it remembers the last set parameter. (Note: a
preceding echo requires the unit to play from buffer memory. If the buffer becomes unavailable the
effect will stop until buffer playback is restored.)
Decimate (hold the Echo button to activate) - this effect reduces the bit rate of the music, creating
increasing distortion. To activate this effect, hold the "Echo" button for 2 seconds.
39. Filter – An isolation (band pass) filter that lets you play only a specific frequency of the music. Rotation
of the wheel moves the filter frequency. If you turn off the effect, then on again, it remembers the last
set parameter value.
Kill (hold the Filter button to activate) - This elimination (band stop) filter lets you play all but a specified
frequency. To activate, hold "Filter" for 2 seconds. Rotation of the wheel moves the filter frequency. If
you turn off the effect, then on again, it remembers the last set parameter value.
When used with "Smart Loop", the unit will adjust all points in 1-beat
The start parameter is no
you will create
This essentially plays an echo ahead of
negative or
7
If a loop has
Tapping the