LP GAS CYLINDER – 1Lb
Use propane cylinders with a capacity of 14.1 oz or 16.4 oz.
You can find these tanks in the camping, hardware or
plumbing section of the store you are shopping at.
16.4oz (1.02 lbs.)
CAUTION: Use cylinders that are marked "propane
fuel" only.
NOTE: Your stove is equipped with a cylinder
supply system designed for vapor withdrawal.
While holding the regulator with one hand, push
cylinder into regulator and turn clockwise until tight.
WARNING: Do not use a wrench to tighten the
connection. Using a wrench could damage the
regulator coupling and could cause a leak.
14.1oz (0.88 lbs.)
propane
SPECIFICATION
1. All LP gas cylinders used with this appliance must
be constructed and marked in accordance with the
Specifications for LP Gas Cylinders of the U.S.
Department of Transportation (D.O.T.) or the National
Standard of Canada, CAN/CSA-B339, Cylinders,
Spheres and Tubes for Transportation of Dangerous
Goods ; and Commission, as applicable.
2. The LP gas cylinder used for this appliance must not have
a capacity larger than 16.4 oz. (.5 kg). Approximately 8"
(20cm) high 3.9" (10cm) diameter.
3. The cylinder must be installed as per assembly
instructions.
STORAGE
1. Store the LP gas cylinder outdoors in a well-ventilated
place.
2. Do not store the LP gas cylinder in direct sunlight, near a
source of heat or combustion.
3. If you intend to store the stove indoors, disconnect and
remove the LP gas cylinder first. Disconnected cylinders
must have a dust cap installed and must not be stored in
a building, garage or any enclosed area.
4. Keep out of the reach of children.
5. When the LP gas cylinder is connected to the gas stove,
the gas stove and LP gas cylinder must be stored outside
in a well-ventilated place.
OPERATION
1. Never connect your gas stove to an LP gas cylinder
without the regulator provided, and NEVER TO AN
UNREGULATED LP GAS SUPPLY. The regulator
supplied with the barbecue must be used.
2. Always leak test the LP gas cylinder to regulator
connection when connecting the LP gas cylinder to the
appliance. See "Leak Testing."
3. Do not operate appliance if the smell of LP gas is
present. Extinguish all flame and determine source of LP
gas before proceeding. Do not ignite the appliance until
the LP gas leak has been found and sealed.
4. Always shut off LP gas cylinder valve when the appliance
is not in use.
3